Ag Leader EDGE Ver.4.5 Users Manual - Manual (Page 186)

174
CAUTION: Do not change settings from the default value of 4 without specific instruction from Technical
Support.
GPS Offsets
After completing the process of setting up a Combine, GPS Offsets must be configured. The GPS
Offsets define where machine parameters are in relation to the GPS antenna. These settings are used
by mapping and AutoSwath.
Antenna Offsets
The Antenna Tab contains three different settings. Accuracy when measuring for a specific setting is
essential to ensure proper machine performance.
• Measure and enter the horizontal distance from the rear axle to
the position of the GPS antenna. Select In Front or Behind from
the list box to indicate the position of the antenna in relation to the
rear axle.
• Measure and enter the horizontal distance from the centerline of
the vehicle to the position of the GPS antenna. Select Left or Right
to indicate the position from the vehicle centerline.
• Measure and enter the vertical height of the antenna above the
ground.
Head Offset
The Head Tab allows you to enter in the distance from the
head attachment point to the rear axle. Use the numeric
keypad to enter in the distance to the axle.
H
EADER
T
AB
Underneath the Header Tab, you can view, add, rename or
remove headers, or adjust header settings.
• Add button
Add a header.
• On-screen Keyboard
Edit or rename existing headers.
• Wrench button
Access Header Settings. For more information, see
“Header
Settings” on page 175.
• Remove button
Remove a header.