HP 3PAR Operating System Software - Manual (Page 523)

snapshot
administration
space The space on a virtual volume that is used to track changes to the data since a snapshot of a
virtual volume was created.
snapshot data Data written to the base volume's snapshot data space to record changes to the base volume
after the first virtual copy of that volume was created.
snapshot data
space The space on a virtual volume that holds the data that has been changed since the first virtual
copy was created.
solid state drive A data storage device that uses solid-state memory to store persistent data.
source system See primary system.
source volume The virtual volume from which a copy is made.
spare, spare
chunklet A chunklet that is reserved for use in case of a failure in the system. A certain number of chunklets
are reserved for use as spares during the system setup and installation process. However, the
system may temporarily set aside additional spares even though these chunklets are not
permanently designated for use as spares.
SSD See solid state drive.
stale snapshot A snapshot that does not track the most recent changes to its base volume. The No Stale Snapshots
virtual copy policy halts writing data to the base volume so as to prevent loss of sync between
the volume and any snapshots. See also virtual copy policy and no stale snapshots.
step size The number of contiguous bytes that the system accesses before moving to the next chunklet.
system manager Software component that negotiates between the storage system and the user interfaces such as
the HP 3PAR Management Console and HP 3PAR CLI.
target mode The firmware setting for a port that is connected to a host.
target, target port The port that is connected to and receives commands from a host computer. Also known as a
host port.
template See VLUN template.
thin provisioning See HP 3PAR Thin Provisioning.
Thinly Provisioned
Virtual Volume
(TPVV) A virtual volume that maps to logical disk space associated with a common provisioning group
(CPG) and is therefore capable of growing on demand.
TPVV See Thinly Provisioned Virtual Volume.
unspecified
property When using the HP 3PAR Management Console, a property that has been included in a template
but does not have a defined value. When applying the template, the system uses the default value
(when applicable) or calculates the optimized setting for you.
user data For standard base volumes, the data that is written to the user space.
user size The amount of user space in a virtual volume, or the size of the volume as presented to the host.
user space The space on a virtual volume that represents the size of the virtual volume as presented to the
host. For standard base volumes, the user space holds all user data. For thinly provisioned virtual
volumes, no storage is actually allocated to user space, so the user space represents the volume's
virtual size. See also virtual size.
virtual copy A snapshot, or copy-in-time, of another volume (a base volume or another virtual copy) created
using copy-on-write techniques.
virtual copy
consistency group A group of snapshots created from multiple virtual volumes at the same time in order to ensure
consistency.
virtual size The size that the volume presents to the host. For standard base volumes, the virtual size is equal
to the user space. For thinly provisioned virtual volumes, no storage is actually allocated to user
space, so the virtual size is determined by whatever value is assigned to the user space. See also
user space.
virtual volume A virtual storage unit created by mapping data from one or more logical disks. See also logical
disk, mapping.
VLUN A pairing between a virtual volume and a Logical Unit Number (LUN), expressed as either a
VLUN template or an active VLUN.
523