HP 3PAR Operating System Software - Manual (Page 37)

The following information is provided:
Description Field Group
The location of the SFP within the system. Position General
Current condition of the SFP. State
Manufacturer of the SFP. Manufacturer
Part number of the SFP. Part Number
Serial number of the SFP. Serial Number
SFP's revision level. Revision
Maximum speed allowed by the SFP. Max Speed
Displays whether the SFP has been tested and if the SFP is supported. Qualified
Displays whether the transmit laser is disabled. TX Disable
Displays whether the transmit laser has a problem. TX Fault
Displays whether the receive end of the SFP is experiencing a loss of
signal from the host or drive cage. RX Loss
Displays whether the SFP receive power is low. RX Power Low
Displays whether the SFP is DDM-capable (Digital Diagnostic
Monitoring). DDM Support
Description Column
Identifies the monitored parameters (temperature, voltage, TX bias, TX
power, and RX power). Type DDM
The unit of measure used for the monitored parameters. Unit
The current measured value. Value
The manufacturer's recommended lower-limit warning level. Low Threshold Warning
The manufacturer's recommended upper-limit warning level. High Threshold Warning
Viewing System Ports 37