HP 3PAR Operating System Software - Manual (Page 35)

Description Field Group
(For RCIP ports.) Model of the adapter that contains the port (for example,
Intel PRO/1000MT). Adapter Type
Type of connection (Private Loop, Public Loop, or Point-Point). Topology Fibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3, or 2/3).
2/3 indicates that both Class 2 and Class 3 are enabled. Class
(displayed for FC
and RCFC ports)
Model of the Fibre Channel adapter that contains the port (for example,
QLOGIC 2302). Adaptor Type
(For RCFC ports.) The node WWN. Remote Node
WWN
(For RCFC ports.) The port WWN. Remote Port WWN
Indicates whether port mode change from initiator to target or vice versa is
Allowed or Prohibited. This setting is configured using the HP 3PAR CLI
command controlport. Mode Change
The number of hosts connected to the port. (This is only displayed if the port
is connected to hosts.) Hosts
The number of physical disks connected to the port. This is only displayed if
the port is connected to drive cages. Physical Disks
(For RCFC ports.) The current state of the link. Link State
Primary Internet Storage Name Service (iSNS) server IP address. iSNS
protocol allows for automated discovery, management, and configuration
of iSCSI. Primary IP Address iSNS Settings
(displayed for
iSCSI ports)
Secondary Internet Storage Name Service (iSNS) server IP address. Secondary IP
Address
The port on the iSNS server with which to communicate. TCP Port
Displays the partner port. Partner Virtual Port
Displays the WWN (displayed for FC and RCFC ports) or the IP (displayed
for iSCSI ports) of the partner port. Partner
WWN/Partner IP
Indicates if the system is in a failover state. Failover State
Physical Disks Tab
The physical disk port information is displayed on the Physical Disks tab.
Viewing System Ports 35