HP 3PAR Operating System Software - Manual (Page 257)

2. In the Common Actions panel, click Remove Peer Volumes.
The Remove Peer Volumes dialog box appears.
3. Select the Select to also delete check box if you want to delete any listed volumes currently
exported to a host and listed volumes that are part of a volume set. If this check box is selected,
a warning dialog appears . Click Delete to remove the volumes.
4. Click OK.
Post Migration Cleanup
The Post Migration Cleanup feature does the following:
•
Unexport all Peer Motion-migrated volumes from the migration host.
•
Remove the VLUNs associated with the volumes being unexported.
•
Remove the migration host from the source system.
NOTE: The migration host is an interim host created by the Peer Motion process. Therefore,
migration cleanup is not complete until the migration host is removed from the source system.
To use the Post Migration Cleanup command, the following conditions are required:
•
Super user role.
•
A Peer Motion configuration that has a source and destination system.
•
No admitted (peer) volumes or importing volumes on the destination system .
•
A migration host exists.
After the system completes the post-migration cleanup, you can start a new migration using the
existing Peer Motion configuration and the current peer ports. To delete the existing Peer Motion
configuration and reconfigure the peer ports as host ports, use the Remove PM Configuration
dialog.
You must complete post-migration cleanup after each migration (import task) finishes.
To remove the migration host after the data migration process is complete:
1.
Select Peer Motion in the Manger Pane.
2. In the Common Actions panel, click Post Migration Cleanups.
The Post Migration Cleanup dialog box appears.
3. Click OK to remove the migration host on the source system.
Post Migration Cleanup 257