Summary, Configuring fibre channel ports, Configuring iscsi ports – HP 3PAR Operating System Software User Manual
Page 25: General
4.
Click Next to view the Summary page, or click Finish to complete the configuration wizard.
Summary
Review your settings, then click Finish to complete the configuration wizard.
Configuring Fibre Channel Ports
To configure a Fibre Channel port, access the Fibre Channel Port Configuration dialog:
1.
In the Manager Pane, select Systems.
2.
In the Management Tree, select the system on which you want to configure the port.
3.
In the Common Actions panel, click Configure FC Port.
The Fibre Channel Port Configuration dialog appears.
4.
In the General group box:
a.
System list - Select the system on which the port will be configured.
b.
Port list - Select the port to be configured as a Fibre Channel port.
5.
In the Settings group box:
a.
Connection Mode list - Select the mode of the port as Disk, Host, RCFC, or Peer.
b.
Connection Type list - Select whether the connection type is Loop or Point.
c.
Unique Node WWN - Enable or disable the node WWN.
d.
Configured Rate - Select Auto (default), 1 Gbps, 2 Gbps, 4 Gbps, or 8* Gbps.
e.
VLUN Change Notification (VCN) - Enable or disable the VLUN change notification.
f.
Interrupt Coalesce - Enable or disable the interrupt coalesce.
6.
Click OK.
*8 Gbps for V-Class Systems only.
Configuring iSCSI Ports
To configure an iSCSI port, access the iSCSI Port Configuration wizard:
1.
In the Manager Pane, select Systems.
2.
In the Management Tree, select the system on which you want to configure the port.
3.
In the Common Actions panel, click Configure iSCSI Port.
The iSCSI Port Configuration wizard appears.
General
1.
In the General group box:
a.
System list - Select the system on which the port will be configured.
b.
Port list - Select the port to be configured as an RCIP port.
2.
In the IP Settings group box, perform the following:
a.
Select Obtain an IP Address automatically.
b.
MTU list - Enter the MTU (maximum transmission units) value.
or
c.
Select Use the following IP address.
d.
IP Address - Enter the iSCSI port's IP address.
e.
Subnet Mask - Enter the iSCSI port's subnet mask.
f.
Gateway - Enter the iSCSI port's gateway address.
g.
MTU list - Enter the MTU (maximum transmission units) value.
3.
Click Finish to complete the iSCSI port configuration, or click Next to enter iSNS settings.
Configuring Ports
25