HP 3PAR Operating System Software - Manual (Page 26)

iSNS Settings
1. Primary IP Address – (Optional) Enter the Internet Storage Name Service (iSNS) IP address.
2. Secondary IP Address – (Optional) Enter the Secondary IP Address.
3. TCP Port – (Optional) Enter the iSNS TCP port. The default port is 3205.
4. Click Finish to complete the iSCSI port configuration, or click Next to view the configuration
summary.
Summary
Review the summary information. When satisfied, click Finish.
Configuring an RCFC Port
To configure a Remote Copy over Fibre Channel (RCFC) port, access the Fibre Channel Port
Configuration dialog:
1.
In the Manager Pane, select Systems.
2. In the Management Tree, select the system on which you want to configure the port.
3. In the Common Actions panel, click Configure FC Port.
The Fibre Channel Port Configuration dialog appears.
4. In the General group box:
a.
System list - Select the system on which the port will be configured.
b. Port list - Select the port to be configured as a Fibre Channel port.
5. In the Settings group box:
a.
Connection Mode list - Select the mode of the port as RCFC.
b. Connection Type list - Select whether the connection type is Loop or Point.
c. Unique Node WWN - Enable or disable the node WWN.
d. Configured Rate - Select Auto (default), 1 Gbps, 2 Gbps, or 4 Gbps.
e. VLUN Change Notification (VCN) - Enable or disable the VLUN (Virtual Logical Unit
Number) change notification.
f. Interrupt Coalesce - Enable or disable the interrupt coalesce.
g. Persona list - The port persona is preselected based on the current configuration.
6. Click OK.
Configuring an RCIP Port
To configure a Remote Copy over IP (RCIP) port, access the RCIP Port Configuration dialog:
1.
In the Manager Pane, select Systems.
2. In the Management Tree, select the system on which you want to configure the port.
3. In the Common Actions panel, click Configure RCIP Port.
The RCIP Port Configuration dialog appears.
4. In the General group box:
a.
System list - Select the system on which the port will be configured.
b. Port list - Select the port to be configured as an RCIP port.
5. In the IP Settings group box:
a.
IP Address - Enter the IP address of the RCIP port. The IP address is required.
b. Subnet Mask - Enter the RCIP port's subnet mask. The subnet mask is required.
c. Gateway - Enter the RCIP port's gateway address.
d. MTU list - Enter the MTU value (maximum transmission units).
e. Speed list - Select the port speed as Auto (default), 10 Mbps, 100 Mbps, or 1 Gbps.
f. Duplex list - Select the port's duplex value of either Half or Full.
26 Managing Ports