Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 564)

FIGURE 89 Example of setting up Enforce LSAN tag
FC router 1 does not need to know about the LSAN between edge fabrics 2 and 3. Likewise, FC router
3 does not need to know about the LSAN between edge fabrics 1 and 2.
In this scenario, you could set up two Enforce tags, one for each LSAN. On FC router 2, both Enforce
tags would be needed, since FC router 2 uses both LSANs. FC router 1 and FC router 3 each need
only one tag, for their respective LSANs.
Setting up Enforce tags in this way keeps resources on FC router 1 and FC router 3 at a minimum.
This is a simple example, but could become more complex as more FIDs are added to each FC router
or as additional FC routers are added to the backbone.
How the Enforce tag works
The FC router automatically accepts all zones with names that start with "lsan_". You can specify an
Enforce tag to indicate that a particular FC router should accept only zones that start with the prefix
"lsan_tag". For example, if you specify an Enforce tag of "abc", the FC router accepts only those LSAN
zones that start with "lsan_abc" and does not import or export any other LSAN zones.
The Enforce tag can be up to eight characters long and can contain only letters and numbers.
The Enforce tag is not case-sensitive; for example, the tag "abc" is equivalent to "ABC" and "Abc".
If you specify "abc", "xyz", and "fab1" as Enforce tags, then the FC router accepts only those LSAN
zones with names that start with any of the following:
• lsan_abc
• lsan_xyz
• lsan_fab1
In this example, the following LSAN zones would all be accepted:
• lsan_abc
• Lsan_xyz123456
• LSAN_FAB1_abc
Using FC-FC Routing to Connect Fabrics
564 Fabric OS Administrators Guide
53-1003130-01