Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 452)

Configuring an FA-PWWN for an HBA connected to an edge switch
To configure an FA-PWWN, assign the FA-PWWN on the edge switch. The FA-PWWN feature is
enabled by default on the HBA. Refer to the Brocade Adapters Administrator’s Guide for a list of
supported HBAs.
1. Log in to the edge switch to which the device is connected.
2. Assign the FA-PWWN.
• If you are manually assigning a WWN, enter the following command:
fapwwn --assign -port [slot/]port -v Virtual_PWWN
• If you want the WWN to be automatically assigned, enter the following command:
fapwwn --assign -port [slot/]port
3. Display the FA-PWWN.
fapwwn --show -port all
You should see output similar to the following sample. The FA-PWWNs are in the VPWWN column.
-----------------------------------------------------------------------
Port PPWWN VPWWN PID Enable MapType
-----------------------------------------------------------------------
0 --:--:--:--:--:--:--:-- 52:00:10:00:00:0f:50:30 10101 Yes Port/Auto
1 --:--:--:--:--:--:--:-- 11:22:33:44:33:22:11:22 -- Yes Port/User
52:00:10:00:00:0f:50:44
10 --:--:--:--:--:--:--:-- 52:00:10:00:00:0f:50:45 -- Yes Port/Auto
4. Display the FA-PWWN on the HBA.
The following steps are to be executed on the server and not the switch.
a) Log in to the server as root.
b) Enter the following command to display the FA-PWWN.
# bcu port --faa_query port_id
FAA state: Enabled
PWWN: 11:22:33:44:33:22:11:22
PWWN source: Fabric
The HBA retains the FA-PWWN until it is rebooted. This means you cannot unplug and
plug the cable into a different port on the switch. You must reboot the HBA before moving
the HBA to a different port.
If you move an HBA to a different port on a switch running Fabric OS v7.0.0 or later, the
HBA will disable its port. The port remains disabled even if you then move the HBA to a
port on a switch running a version of Fabric OS earlier than 7.0.0.
Supported switches and configurations for FA-PWWN
The FA-PWWN feature is supported only on switches running Fabric OS 7.0.0 or later and only on
Brocade HBAs and adapters. The HBA can be connected to an edge switch or to an Access Gateway
switch.
The FA-PWWN feature is supported on the following platforms:
• Switch platforms running Fabric OS v7.0.0 or later:
Configuring an FA-PWWN for an HBA connected to an edge switch
452 Fabric OS Administrators Guide
53-1003130-01