Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 520)

FIGURE 81 Switch in Access Gateway mode with F_Port masterless trunking
NOTE
You do not need to map the host to the master port manually because the Access Gateway will
perform a cold failover to the master port.
Refer to Configuring F_Port trunking for an Access Gateway on page 520 for instructions on
configuring F_Port trunking.
Requirements for F_Port trunking on an Access Gateway
In addition to the requirements listed in Requirements for trunk groups on page 512, refer to the
Access Gateway Administrator's Guide for additional requirements that are specific to F_Port trunking
on an Access Gateway.
Configuring F_Port trunking for an Access Gateway
Access Gateway trunking configuration is mostly on the edge switch. On the Access Gateway module,
you only need to ensure that the Trunking license is applied and enabled.
Use the following procedure on the edge switch connected to the Access Gateway module to
configure F_Port trunking.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the portCfgShow command to ensure that the ports have trunking enabled. If trunking is not
enabled, enter the portCfgTrunkPortport1 command.
3. Enter the portDisable command for each port to be included in the TA.
4. Enter theportTrunkArea --enable command to enable the trunk area.
Requirements for F_Port trunking on an Access Gateway
520 Fabric OS Administrators Guide
53-1003130-01