Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 203)

linkLIRRListenerRemoved: YES
linkRLIRFailureIncident: YES
HA-TRAP: YES
fruStatusChanged: YES
cpStatusChanged: YES
fruHistoryTrap: YES
ISCSI-TRAP: YES
iscsiTgtLoginFailure: YES
iscsiIntrLoginFailure: YES
iscsiInstSessionFailure: YES
IF-TRAP: YES
linkDown: YES
linkUp: YES
BD-TRAP: YES
bdTrap: YES
bdClearTrap: YES
MAPS-TRAP: YES
mapsTrapAM: YES
T11-FC-ZONE-SERVER-TRAP: YES
t11ZsRequestRejectNotify: YES
t11ZsMergeFailureNotify: YES
t11ZsMergeSuccessNotify: YES
t11ZsDefZoneChangeNotify: YES
t11ZsActivateNotify: YES
To set the system group:
DCX_128:FID128:admin> snmpconfig --set systemgroup
Example of systemGroup configuration (default)
switch:admin> snmpconfig --default systemGroup
*****
This command will reset the agent's system group configuration back to
factory default
*****
sysDescr = Fibre Channel Switch
sysLocation = End User Premise
sysContact = Field Support
authTraps = 0 (OFF)
*****
Are you sure? (yes, y, no, n): [no] y
3. Set the security level.
switch:admin> snmpconfig --set secLevel
Select SNMP GET Security Level
(0 = No security, 1 = Authentication only, 2 = Authentication and Privacy, 3 = No
Access): (0..3) [0] 2
Select SNMP SET Security Level
(0 = No security, 1 = Authentication only, 2 = Authentication and Privacy, 3 = No
Access): (2..3) [2] 2
switch:admin> snmpconfig --show secLevel
GET security level = 2, SET level = 2
SNMP GET Security Level: Authentication and Privacy
SNMP SET Security Level: Authentication and Privacy
To set the security level to default:
DCX_128:FID128:admin> snmpconfig --default seclevel
GET security level = 0, SET level = 0
SNMP GET Security Level: No security
SNMP SET Security Level: No security
SNMP GET Security Level will be set to 'No Security'
SNMP SET Security Level will be set to 'No Security'
Do you want to continue? (yes, y, no, n): [no] y
DCX_128:FID128:admin>
DCX_128:FID128:admin> snmpconfig --show seclevel
GET security level = 0, SET level = 0
SNMP GET Security Level: No security
SNMP SET Security Level: No security
DCX_128:FID128:admin
4. In the Manager (SNMP Browser), create a user snmpadmin1 with Authentication protocol as noAuth,
Privacy protocol as noPriv, set the password and set the trap port as 162. (Same values are set as in
the switch SNMPv3 configuration.)
Configuring Protocols
Fabric OS Administrators Guide 203
53-1003130-01