Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 334)

Zone merging scenarios: TI zones (Continued) TABLE 67
Description Switch A Switch B Expected results
Switch A has a TI zone.
Switch B has a different TI zone.
defined: cfg1
TI_zone1
defined: cfg1
TI_zone2
Fabric segments due to: Zone Conflict cfg
mismatch. Cannot merge switches with
different TI zone configurations.
Switch A has Enhanced TI zones.
Switch B is running Fabric OS v6.4.0 or
later.
defined: cfg1
TI_zone1
TI_zone2
defined: none Clean merge. TI zones are not
automatically activated after the merge.
Switch A has Enhanced TI zones.
Switch B is running a Fabric OS
version earlier than v6.4.0.
defined: cfg1
TI_zone1
TI_zone2
defined: none Fabric segments because all switches in
the fabric must be running Fabric OS
v6.4.0 or later to support Enhanced TI
zones.
Zone merging scenarios: Default access mode (pre-Fabric OS 7.3.0) TABLE 68
Description Switch A Switch B Expected results
Different default zone
access mode settings. defzone: allaccess defzone: noaccess Clean merge -- noaccess takes
precedence and defzone
configuration from Switch B
propagates to fabric.
defzone: noaccess
Same default zone
access mode settings. defzone: allaccess defzone: allaccess Clean merge -- defzone
configuration is allaccess in the
fabric.
defzone: noaccess defzone: noaccess Clean merge -- defzone
configuration is noaccess in the
fabric.
Effective zone
configuration. No effective
configuration.defzone =
allaccess effective: cfg2
defzone: allaccess or
noaccess
Clean merge -- effective zone
configuration and defzone mode
from Switch B propagates to
fabric.
Effective zone
configuration. No effective
configuration.defzone =
noaccess effective: cfg2
defzone: allaccess
Fabric segments because Switch
A has a hidden zone
configuration (no access)
activated and Switch B has an
explicit zone configuration
activated.
Effective zone
configuration effective: cfg1
defzone: noaccess
No effective
configuration.
defzone: noaccess
Clean merge -- effective zone
configuration from Switch A
propagates to fabric.
Effective zone
configuration effective: cfg1
defzone: allaccess
No effective
configuration.
defzone: noaccess
Fabric segments. You can
resolve the zone conflict by
changing defzone to noaccess on
Switch 1 .
Administering Advanced Zoning
334 Fabric OS Administrators Guide
53-1003130-01