Brocade Fabric OS Administrators Guide (Supporting Fabric OS v7.3.0) - Manual (Page 289)

Executing the switchShow command in a different logical switch context
sw0:FID128:admin> fosexec --fid 4 -cmd "switchshow"
---------------------------------------------------
"switchshow" on FID 4:
switchName: switch_4
switchType: 66.1
switchState: Online
switchMode: Native
switchRole: Principal
switchDomain: 14
switchId: fffc0e
switchWwn: 10:00:00:05:1e:82:3c:2b
zoning: OFF
switchBeacon: OFF
FC Router: OFF
Fabric Name: Fab4
Allow XISL Use: ON
LS Attributes: [FID: 4, Base Switch: No, Default Switch: No, Address Mode 0]
Index Port Address Media Speed State Proto
==============================================
22 22 0e1600 -- N8 No_Module FC Disabled
23 23 0e1700 -- N8 No_Module FC Disabled
Executing the fabricShow command on all logical switches
sw0:FID128:admin> fosexec --fid all -cmd "fabricshow"
---------------------------------------------------
"fabricshow" on FID 128:
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
-------------------------------------------------------------------------
97: fffc61 10:00:00:05:1e:82:3c:2a 10.32.79.105 0.0.0.0 >"sw0"
---------------------------------------------------
"fabricshow" on FID 4:
Switch ID Worldwide Name Enet IP Addr FC IP Addr Name
-------------------------------------------------------------------------
14: fffc0e 10:00:00:05:1e:82:3c:2b 10.32.79.105 0.0.0.0 >"switch_4"
(output truncated)
Deleting a logical switch
The following rules apply to deleting a logical switch:
• You must remove all ports from the logical switch before deleting it.
• You cannot delete the default logical switch.
NOTE
If you are in the context of the logical switch you want to delete, you are automatically logged out when
the fabric ID changes. To avoid being logged out, make sure you are in the context of a different logical
switch from the one you are deleting.
1. Connect to the physical chassis and log in using an account with admin permissions.
2. Remove all ports from the logical switch as described in
Adding and moving ports on a logical switch
on page 290.
3. Enter the lsCfg command to delete the logical switch:
lscfg --deletefabricID
The fabricID parameter is the fabric ID of the logical switch to be deleted.
Deleting a logical switch
Fabric OS Administrators Guide 289
53-1003130-01