Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 72)

2-42
IM 04L31A01-17E
10. Press the [Input] soft key. An entry box appears.
11. Enter the port number in the entry box.
12. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The port number that you entered appears in the [Port number] box.
• Setting Recipient 1
13.
Use the arrow keys to move the cursor to the [Recipient 1] box.
14. Press the [Input] soft key. An entry box appears.
15. Enter the recipient address in the entry box.
When entering multiple address, delimit each address with a space.
16. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The addresses that you entered are displayed in the [Recipient 1] box.
• Setting Recipient 2
17.
Use the arrow keys to move the cursor to the [Recipient 2] box.
18. Set the recipient 2 addresses in the same fashion as the recipient 1 addresses.
• Setting the sender address
19.
Use the arrow keys to move the cursor to the [Sender] box.
20. Press the [Input] soft key. An entry box appears.
21. Enter the sender address in the entry box.
22. Press the DISP/ENTER key. On the CX1000, select [ENT] and then press the
DISP/ENTER key.
The addresses that you entered are displayed in the [Sender] box.
• Confirming or Canceling the Settings
23.
To confirm the new settings, press the DISP/ENTER key. To cancel the
settings, press the ESC key.
For a detailed procedure in confirming or canceling settings, see “Setup Procedure Using
Operation Keys” on page ix.
Proceed to step 24.
2.11 Setting the E-mail Transmission Function