Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 70)

2-40
IM 04L31A01-17E
Settings When Transmitting E-mail Messages at the Time of Recovery from a
Power Failure (System E-Mail Settings)
• Recipient 1, Recipient 2
You can turn On/Off the function for each recipient.
• On
Transmits e-mail messages to the recipient.
• Off
Does not transmit e-mail messages to the recipient.
• Contents of the transmitted mail
• Including the source URL (Uniform Resource Locator)
• On
If the Web server function is specified on the CX, the URL of the CX is
attached to the e-mail.
• Off
The URL of the CX is not attached to the e-mail.
• Subject
Set the subject of the e-mail message using up to 32 alphanumeric characters.
The default value is “(CX)System_warning.”
• Header 1
Set the string to be attached to the e-mail message using up to 64 alphanumeric
characters.
• Header 2
Set the string to be attached to the e-mail message using up to 64 alphanumeric
characters.
Settings When Transmitting E-mail Messages at the Time of Reports Are Created
(Only on Models with the Computation Function Option (/M1))
• Recipient 1, Recipient 2
You can turn On/Off the function for each recipient.
• On
Transmits e-mail messages to the recipient.
• Off
Does not transmit e-mail messages to the recipient.
• Contents of the transmitted mail
• Including the source URL (Uniform Resource Locator)
• On
If the Web server function is specified on the CX, the URL of the CX is
attached to the e-mail.
• Off
The URL of the CX is not attached to the e-mail.
• Subject
Set the subject of the e-mail message using up to 32 alphanumeric characters.
The default value is “(CX)Report_data.”
• Header 1
Set the string to be attached to the e-mail message using up to 64 alphanumeric
characters.
• Header 2
Set the string to be attached to the e-mail message using up to 64 alphanumeric
characters.
Saving the Settings
To activate the settings that have been changed in the basic setting mode, the settings
must be saved. Otherwise, the settings that existed before the change are activated.
Note
The “°” set on the CX is displayed as “^” on the Web browser.
2.11 Setting the E-mail Transmission Function