Yokogawa Data Acquisition with PID Control CX2000 User Manual
Page 47

2-17
IM 04L31A01-17E
Ethernet Interface
2
2.7
Setting the Login and Timeout Functions of
Ethernet Communications
Explanation
By setting these functions, you can prohibit invalid access from the network to the CX,
authorize setup operations of the CX via the Ethernet network, and disconnect
connections if there is no data transmission for a certain time. To use this function,
however, the Ethernet interface must be configured as described in section 2.3.
Enabling/Disabling the Login Function of the CX
If you enable the login function, only registered users can log in to the CX.
Registering Users
• Selecting user levels
Select either user level: ADMINISTRATOR or USER.
• ADMINISTRATOR
A single ADMINISTRATOR can be registered. The ADMINISTRATOR has the
authority to use all the functions of the Setting/Measurement server,
Maintenance/Test server, and FTP server.
• USER (USER 1 to USER 6)
Up to 6 USERs can be registered. Certain restrictions exist in using the Setting/
Measurement server, Maintenance/Test server, and FTP server. For the
restrictions against commands, see section 6.2.
• Restrictions in using the Setting/Measurement server
USERs are not authorized to change the settings that would change the
operation of the CX. USERs can output measured and setup data.
• Restrictions in using the Maintenance/Test server
USERs cannot disconnect connections between other PCs and the CX.
USERs can disconnect the connection between their own PC and the CX.
• Restrictions in using the FTP server
Files cannot be written to or deleted from the external storage medium of the
CX. Files can be read.
• Selecting whether to register (On/Off)
• On
Registers users. You can set the user name and password for logging in.
• Off
Register users.
• Setting the user name
• Enter the user name using up to 16 alphanumeric characters.
• You cannot register the same user names.
• You cannot register the user name “quit,” because “quit” is used as a command
on the CX.
• Setting the password
Set the password using up to six alphanumeric characters.