Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 309)

App-50
IM 04L31A01-17E
Appendix 7 Messages
Operation Errors
• Errors Related to the External Storage Medium
Code Message Explanation/Countermeasures/Ref. section
200 Operation aborted because an error was found in media. Check the external storage medium.
214 There is no file or directory. Section 6.11
• Errors Related to E-mail and Web Server
Code Message Explanation/Countermeasures/Ref. section
260 IP address is not set or ethernet function is not available. The IP address is not specified. Check the IP
address.
261 SMTP server is not found. Occurs when the SMTP server is specified by
name.
•
Check the DNS setting.
• Check the SMTP server name.
262 Cannot initiate E-mail transmission. • The host name of the CX is not correct.
Check the host name.
• The port number of the SMTP server is not
correct. Check the port number.
263 Sender’s address rejected by the server. Check the sender’s address.
264 Some recipients’ addresses are invalid. Check the recipient’s address.
265 SMTP protocol error. May occur if a network failure (cable problems,
duplicate addresses, network device failure,
and so on) occurs in the middle of the e-mail
transmission.
266 Ethernet cable is not connected. Check the cable connection.
267 Could not connect to SMTP server. • Check to see that the SMTP server is
connected to the network.
• If the SMTP server name is specified using
an IP address, check to see that the IP
address is correct.
268 E-mail transmission request failed. Contact your nearest YOKOGAWA dealer.
269 E-mail transfer error. May occur if a network failure (cable problems,
duplicate addresses, network device failure,
and so on) occurs in the middle of the e-mail
transmission.
275 The current image cannot be output to the Web. The setup display cannot be output to the Web
browser.
This message is displayed on the Web browser.
276 Image data currently being created. Unable to perform key operation. Try again a little later.
This message is displayed on the Web browser.
277 Could not output screen to Web. Failed to create the image.
This message is displayed on the Web browser.