Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 7)

vi
IM 04L31A01-17E
Conventions Used in This Manual
Unit
• k: Denotes “1000.” Example: 5 kg, 100 kHz
• K: Denotes “1024.” Example: 640 KB (storage capacity of floppy disks)
Symbols
The following symbols are used in this manual.
A symbol affixed to the instrument. Indicates danger to personnel
or instrument and the operator must refer to the user’s manual.
The symbol is used in the User’s Manual to indicate the reference.
WARNING Calls attention to actions or conditions that could cause serious
injury or death to the user, and precautions that can be taken to
prevent such occurences.
CAUTION Describes precautions that should be observed to prevent minor or
moderate injury, or damage to the instrument.
Note Provides important information for the proper operation of the
instrument.
Displayed Characters
Alphanumeric characters enclosed by brackets are mainly characters and numbers
that appear on the display.
Symbols Used on Pages Describing Operating Procedures
On pages that describe the operating procedures in chapters 2 through 9, the
following symbols are used to distinguish the procedures from their explanations.
Explanation
This section describes the setup parameters and the limitations
regarding the procedures.
Procedure
Carry out the procedure according to the step numbers. The
procedures are given with the premise that the user is carrying out
the steps for the first time. Depending on the operation, not all
steps need to be taken.
How to Use This Manual