Yokogawa Data Acquisition with PID Control CX2000 - Manual (Page 313)

App-54
IM 04L31A01-17E
Appendix 7 Messages
Communication Errors
• Errors during Setting and Basic Setting Modes, Output Communication Command
Execution, and Setup Data Loading
Code Message
300 Command is too long.
301 Too many number of commands delimited with ‘;’.
302 This command has not been defined.
303 Data request command can not be enumerated with sub-delimiter.
350 Command is not permitted to the current user level.
351 This command cannot be specified in the current mode.
352 The option is not installed.
353 This command cannot be specified in the current setting.
354 This command is not available during sampling, calculating or controlling.
357 The setup output command cannot be executed in this condition.
• Memory Access Errors during Setting and Basic Setting Modes and Output
Communication Command Execution
An English error message is returned via the communication interface. It is not
displayed on the screen.
Code Message
360 Output interface must be chosen from Ethernet or RS by using ‘XO’ command.
361 The memory data is not saved for the communication output.
362 There are no data to send ‘NEXT’ or ‘RESEND’.
363 All data have already been transferred.
370 Command is not permitted to the current model.
• Maintenance and Test Communication Command Errors
An English error message is returned via the communication interface. It is not
displayed on the screen.
Code Message
390 Command error.
391 Delimiter error.
392 Parameter error.
393 No permission.
394 No such connection.
395 Use ‘quit’ to close this connection.
396 Failed to disconnect.
397 No TCP control block.