Yokogawa Touch Screen GP20 - Manual (Page 184)

1-170
IM 04L51B01-01EN
1.24.2 Reconfiguring the GX/GP
When you reconfigure the GX/GP, the installed I/O modules are detected, and the settings
are changed accordingly.
Reconfiguration is necessary in the following situations.
• When you install a newly purchased module
• When you change the modules (change to different modules)
• When you add or remove modules
If you purchased a I/O module preinstalled option (/U□□0 or /CR□□0), there is no need to
reconfigure if you are going to use the GX/GP as-is.
However, if you change modules, add modules, or delete modules, you will need to
reconfigure.
Path
GX/GP: MENU key > Browse tab > Initialize Calibration > Menu Reconfiguration
Procedure
1
Tap Execute.
The system information appears.
Switches the display
X X X X X X X X X XX-XX-XX-XX-XX-XX
RX.XX.XX RX.XX.XX
2
Tap Restructure.
A confirmation screen is displayed.
3
Tap OK.
The GX/GP will reconfigure.
Operation complete
Note
• Do not carry out the following operations while the GX/GP is reconfiguring. Doing so may cause
damage.
Turn the power off and on.
Insert or remove modules.
• If the total number of I/O channels of the installed modules exceeds 100 (GX20/GP20) or 48
(GX10/GP10) , no additional modules can be reconfigured.
1.24.3 Adjusting the Touch Screen
See page 5-6 in section 5.1.4, “Adjusting and Checking the Touch Screen”.
1.24 Initializing and Calibrating the System (Initialization, reconfiguration, touch screen calibration)