Yokogawa Touch Screen GP20 - Manual (Page 122)

1-108
IM 04L51B01-01EN
1.14 Configuring the Event Action Function
The event action function is used to execute a specified action on the basis of events that
occur. The settings explained here are also used to configure the remote control function.
1.14.1 Setting Event Action Numbers and Actions
Path
GX/GP: MENU key > Browse tab > Setting > Setting menu Event action
Web browser: Config. tab > Event action
Hardware configurator: Event action
Description
Setup Item Selectable Range or Options Default Value
Event action number 1 to 50 1
Event action number
Select the event action number to assign an event action.
Event action
Setup Item Selectable Range or Options Default Value
On/Off Off, On Off
On/Off
Select On to use the event action function.
Event 1
Setup Item Selectable Range or Options Default Value
Type Internal switch, Remote, 4 Relay, Alarm - I/O channel,
Alarm - Math channel, Alarm - Communication
channel, Any alarm, Timer, Match time timer
Internal switch
Number 2 I/O channel, Math channel, Communication channel 1
Alarm level 3 1 to 4 1
Operation mode Rising edge, Falling edge, Rising/Falling edge, Edge 5 Rising edge
1 Appears when Event action is set to On.
2 Does not appear when Type is set to Any alarm.
3 Appears when the Type is to Alarm - I/O channel, Alarm - Math channel, or Alarm -
Communication channel.
4 Appears when the operation mode of the DI module is set to Remote.
5 Appears when the event is set to Timer or Match time timer.