beautypg.com

Network length, Baud rate (data rate), Node address (mac id) – Watlow Series D8 User Manual

Page 60: Network length 42, Baud rate (data rate) 42, Node address (mac id) 42, Table 2.9—maximum network speed 42

background image

Chapter 2: Installation

Series D8 User’s Guide

42

Watlow Anafaze

Doc. 0600-3120-2000

Network Length

The network speed is limited by the end-to-end network dis-

tance. The longer the network, the slower the baud rate setting

must be. See Table 2.9

Table 2.9

Maximum Network Speed

Baud Rate (Data Rate)

DeviceNet communications can use three different baud rates

(data rates) 125k, 250k, and 500k baud. When the switch is set

to the PGM position, the unit's baud rate is determined by a

software setting. If the switch is set to PGM you must set the

data rate using the controller’s front panel or network-config-

uration software. As long as the switch is set to PGM, the con-

troller will always come back up on the network with the last

software-configured baud rate stored in the controller's mem-

ory.
As an example, assume the controller's baud rate switch is set

to PGM, and it is programmed at 500k baud. Assume too, that

the DeviceNet network experiences a power loss. When pow-

er is restored, the controller will come back up with a baud

rate of 500k baud. If on the other hand, the baud rate switch

was changed to 250k baud before the network power had been

restored, the controller will attempt to come back on the net-

work at 250k baud.

NOTE!

When changing the baud rate via the soft-
ware or by manually changing the switch po-
sition, you will need to cycle power on the
network for the change to take effect.

Node Address (MAC ID)

Valid node addresses on a DeviceNet network range from 0 to

63 decimal. When the switch is set to the PGM position, the

unit's node address is determined by a software setting. If the

switch is set to “PGM” you must set the node address using

the controller’s front panel or network-configuration soft-

ware. As long as the switch setting remains set for software

Distance

Baud Rate

100 m (328 ft)

500 Kbps

250 m (820 ft)

250 Kbps

500 m (1,640 ft)

125 Kbps