Job display, Job display 83, Table 4.3—system alarm messages 83 – Watlow Series D8 User Manual
Page 101

Series D8 User’s Guide
Chapter 4: Operation and Setup
Doc. 0600-3120-2000
Watlow Anafaze
83
Table 4.3
System Alarm Messages
Job Display
The job display appears if you load a job from memory. If you
load a job using the Load setup from job parameter, the job
display shows the following screen:
If the job was loaded using digital inputs, the display shows
this screen:
If parameters are modified while the job is running, the dis-
play shows this screen:
To toggle between the job display and the loop display, press
> or <.
Message
Description
Low power
The power supply has failed. See Low Power on page 163.
Battery dead
The RAM battery in the D8 is not functioning correctly, and stored data
has been corrupted. See Battery Dead on page 163.
H/W error:
Ambient
The temperature around the controller is outside of the acceptable range
of -5 to 55°C. See H/W Error: Ambient on page 165.
H/W error:
Gain
Hardware failed because of excessive voltage on inputs. See H/W Error:
H/W error:
Offset
Job 1 running
Job 1 running
remotely loaded
Job 1 running
Data modified