Configuring dual dac outputs, Configuring dual dac outputs 177, Figure 7.6—dual dac 177 – Watlow Series D8 User Manual
Page 195: Table 7.10—dual dac jumper settings 177, Anaf aze
Series D8 User’s Guide
Chapter 7: Troubleshooting and Reconfiguring
Doc. 0600-3120-2000
Watlow Anafaze
177
Configuring Dual DAC Outputs
Dual DAC modules ship with both of the outputs configured
for the signal type and span that were ordered. The module
contains two independent circuits (DAC 1 and DAC 2). These
circuits can be configured for different output types. Remove
the board from the housing and set the jumpers. The odd-num-
bered jumpers determine the signal from DAC 1; the even-
numbered jumpers determine the output from DAC 2.
Figure 7.6
Dual DAC
Table 7.10
Dual DAC Jumper Settings
Output
Type
Jumper Settings
1/2
3/4
5/6
7/8
9/10
11/12
13/14
0 to 5 Vdc
B
A
A
O
B
A
O
0 to 10 Vdc
B
A
A
O
B
O
O
4 to 20 mA
O
A
B
A
A
O
A
A = Load jumper in the “A” position, or load jumper if header has
only two pins.
B = Load jumper in the “B” position.
O = Open. Do not load jumper.
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
+5V IN DZC IN
+10-24V IN V OUT
I SINK OUT
COM
+5V IN DZC IN
+10-24V IN V OUT
I SINK OUT
COM
DAC 2
DAC 1
ANAF
AZE
DUAL
DAC