Watlow Series D8 - Manual (Page 104)

Chapter 4: Operation and Setup Series D8 User’s Guide
86 Watlow Anafaze Doc. 0600-3120-2000
Accessing and Navigating the Setup Menus
Use the setup menus to configure the controller. For a list of
all setup menus and parameters, refer to Figure 6.2 on page
124.
How to Access the Setup Menus
To access the setup menus, press and hold x for three sec-
onds, until the Global setup menu appears.
To prevent unauthorized personnel from accessing setup pa-
rameters, the controller reverts to the regular display if you do
not press any keys for three minutes.
How to Edit a Setup Parameter
To edit a setup parameter, go to the appropriate setup menu,
go to the parameter, then edit the value:
1. Press and hold x for three seconds to access the setup
menus.
2. Press < to go to the appropriate a menu.
3. If applicable, press p to choose the loop that you
want to edit.
4. Press . to go to the parameter that you want to edit.
5. To edit a parameter:
• Press < or > to choose a value.
• Press . to save the new value and go to the next pa-
rameter.
• Press x to cancel a change without saving.
6. Repeat from step 4 to edit another parameter in the cur-
rent menu.
7. Press x to return to the top-level menus.
8. Repeat from step 2 to go to another menu, or press x to
exit the setup menus.
For information about setting parameters through communi-
cations, see Appendix A, DeviceNet Interface.