Watlow Series D8 User Manual
Series d8 user’s guide
Series D8
User’s Guide
Watlow Anafaze
1241 Bundy Blvd.
Winona, MN 55987
Customer Service:
Phone ....... 1-800-414-4299
Fax ........... 1-800-445-8992
Technical Support:
Phone ....... (507) 494-5656
Fax ........... (507) 452-4507
Email ........ [email protected]
Part No. 0600-3120-2000 Rev.
B
November 2008
Table of contents
Document Outline
- Cover
- Warranty
- Table of Contents
- List of Figures
- List of Tables
- System Overview
- Installation
- Communicating by DeviceNet
- Operation and Setup
- General Navigation Map
- Keypad
- Displays
- Changing the Set Point
- Changing the Control Mode and Output Power
- Accessing and Navigating the Setup Menus
- Setting Up Closed-Loop Control
- Setting Up a Process Input
- Autotuning
- Setting Up Alarms
- Setting Up Process Variable Retransmit
- Setting Up Cascade Control
- Setting Up Ratio Control
- Setting Up Differential Control
- Setting Up Remote Analog Set Point
- Tuning and Control
- Menu and Parameter Reference
- Operator Parameters
- Overview of the Setup Menus
- Global Setup Menu
- Load Setup From Job
- Save Setup As Job
- BCD Job Load
- BCD Job Load Logic
- Mode Override
- Mode Override Digital Input Active
- Power Up Alarm Delay
- Power Up Loop Mode
- Keypad Lock
- Thermocouple Short Alarm
- AC Line Frequency
- Digital Output Alarm Polarity
- MAC ID
- Baud Rate
- Module LED
- Network LED
- Bus Off Count
- Model and Firmware Version
- Input Menu
- Control Menu
- Output Menu
- Alarms Menu
- Process Variable Retransmit Menu
- Cascade Menu
- Ratio Menu
- I/O Tests Menu
- Parameters Only Available via Communications
- Troubleshooting and Reconfiguring
- Specifications
- Glossary
- Index
- Menu Structure