ALLIED Vision Technologies Stingray F-504 - Manual (Page 94)

Camera interfaces
STINGRAY Technical Manual V4.4.4
92
Camera I/O connector pin assignment
(For board level see Chapter Board level camera: I/O pin assignment on page 93)
Figure 42: Camera I/O connector pin assignment
Note

GP = General Purpose
For a detailed description of the I/O connector and its
operating instructions see the Hardware Installation
Guide, Chapter STINGRAY input description.
Read all Notes and Cautions in the Hardware Installation
Guide, before using the I/O connector.
1
10 2
9
8
7
6
12 11 3
4
5
Pin Signal Direction Level Description
1 External GND GND for RS232 and
ext. power External Ground for RS232
and external power
2 External Power +8...+36 V DC Power supply
3 Camera Out 4 Out Open emitter Camera Output 4

(GPOut4)

default: -
4 Camera In 1 In U
in
(high) = 3 V...24 V

U
in
(low) = 0 V...1.5 V
Camera Input 1

(GPIn1)

default: Trigger
5 Camera Out 3 Out Open emitter Camera Output 3

(GPOut3)

default: Busy
6 Camera Out 1 Out Open emitter Camera Output 1

(GPOut1)

default: IntEna
7 Camera In GND In Common GND for
inputs Camera Common Input
Ground (In GND)
8 RxD RS232 In RS232 Terminal Receive Data
9 TxD RS232 Out RS232 Terminal Transmit Data
10 Camera Out
Power
In Common VCC for

outputs

max. 36 V DC
External Power

for digital outputs

(OutVCC)
11 Camera In 2 In U
in
(high) = 3 V...24 V

U
in
(low) = 0 V...1.5 V
Camera Input 2

(GPIn2)

default: -
12 Camera Out 2 Out Open emitter Camera Output 2

(GPOut2)

default: Follow CameraIn2