ALLIED Vision Technologies Stingray F-504 - Manual (Page 91)

Camera interfaces
STINGRAY Technical Manual V4.4.4
89
Camera interfaces
This chapter gives you detailed information on status LEDs, inputs and out-
puts, trigger features and transmission of data packets.
IEEE 1394b port pin assignment
The IEEE 1394b connector is designed for industrial use and has the following
pin assignment as per specification:
Note

For a detailed description of the camera interfaces
(FireWire, I/O connector), ordering numbers and operat-
ing instructions see the Hardware Installation Guide,
Chapter Camera interfaces.
Read all Notes and Cautions in the Hardware Installation
Guide, before using any interfaces.
Figure 40: IEEE 1394b connector
Note

• Both IEEE 1394b connectors with screw lock mecha-
nism provide access to the IEEE 1394 bus and thus
makes it possible to control the camera and output
frames. Connect the camera by using either of the con-
nectors. The other connector can be used to daisy chain
a second camera.
• Cables with latching connectors on one or both sides
can be used and are available with lengths of 5 m or
7.5 m. Ask your local dealer for more details.
1 2 3 4
5 6 7 8 9
Pin Signal
1 TPB-
2 TPB+
3 TPA-
4 TPA+
5 TPA (Reference ground)
6 VG (GND)
7 N.C.
8 VP (Power, VCC)
9 TPB (Reference ground)