Tektronix MTG100 User Manual
Page 209
Appendix C: Using the ReMux Application
CĆ10
MTG100 & MTG300 MPEG Generator User Manual
Figure CĆ6: Edit TS Information dialog box
In this dialog box, you can set the following parameters:
H File: Specifies the transport stream file to be converted to a transport stream
file of S-TMCC structure.
H Data Rate: Specifies the data rate of the transport stream. You cannot set the
value exceed the data rate of the effective slots. If this value is less than the
data rate of the effective slot, in addition, conversion of the data rate is done
with the insertion of null packets.
H Contract Slots: Shows the number of contract slots. This value depends on
the number of slots set in the Modulation item.
H Modulation: Specifies the modulation system and the number of slots to be
assigned to HQ and LQ when performed hierarchical data transfer.
H HQ: Specifies the modulation system and the number of slots to be
assigned to HQ level.
H LQ: Specifies the modulation system and the number of slots to be
assigned to LQ level. This field is enabled only when the hierarchical
control descriptor exists in PMT.
H TS ID: Specifies the transport stream ID. This value is used to change the
ID value in TMCC, and the ID value in PAT is not changed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com