Tektronix MTG100 - Manual (Page 178)

Appendix B: Using MTG Comm + for File Transfers
MTG100 & MTG300 MPEG Generator User Manual
BĆ5
Ethernet Parameters for the MPEG Generator. Perform the following procedure to
set the Ethernet network parameters for the MPEG generator:
1. Select Network... from the Utility pull-down menu on the MPEG generator.
This will open the Network dialog box shown in Figure B-2.
The settings you enter in the Network dialog box depend on how you
connect the MPEG generator to the remote PC. You can connect the MPEG
generator directly to a single PC or you can connect it to your local Ethernet
network.
Figure BĆ2: Network dialog box for the MPEG generator
2. If you connect the MPEG generator directly to a single PC, perform the
following steps to set the Network dialog box parameters:
a. Set the DHCP Client parameter to Disable.
b. Set the IP Address parameter to be the same IP address as the PC’s
address except for the last number. The last number must be different
than the last number in the PC’s IP address.
c. Set the Subnet Mask parameter to be the same subnet mask used by the
PC. Do not enter a number if the PC does not have a subnet mask.
d. You do not need to enter a Routing Destination or Routing Gateway if
you are directly connected to a single PC.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com