HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 97)

HEIDENHAIN iTNC 530 97
3.8
UNIVER
SAL
PECKING
(Cy
cle
205,
DIN/ISO:
G205)
Cycle parameters
 Set-up clearance
Q200 (incremental): Distance
between tool tip and workpiece surface. Input range
0 to 99999.9999; alternatively PREDEF
 Depth Q201 (incremental): Distance between
workpiece surface and bottom of hole (tip of drill
taper). Input range -99999.9999 to 99999.9999
 Feed rate for plunging
Q206: Traversing speed of
the tool during drilling in mm/min. Input range 0 to
99999.999; alternatively FAUTO, FU
 Plunging depth
Q202 (incremental): Infeed per cut.
Input range 0 to 99999.9999. The depth does not
have to be a multiple of the plunging depth. The TNC
will go to depth in one movement if
 the plunging depth is equal to the depth
 the plunging depth is greater than the depth
 Workpiece surface coordinate
Q203 (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
 2nd set-up clearance
Q204 (incremental): Coordinate
in the spindle axis at which no collision between tool
and workpiece (fixtures) can occur. Input range 0 to
99999.9999; alternatively PREDEF
 Decrement
Q212 (incremental): Value by which the
TNC decreases the plunging depth Q202. Input range
0 to 99999.9999
 Minimum plunging depth Q205 (incremental): If you
have entered a decrement, the TNC limits the
plunging depth to the value entered with Q205. Input
range 0 to 99999.9999
 Upper advanced stop distance
Q258 (incremental):
Set-up clearance for rapid traverse positioning when
the TNC moves the tool again to the current plunging
depth after retraction from the hole; value for the first
plunging depth. Input range 0 to 99999.9999
 Lower advanced stop distance
Q259 (incremental):
Set-up clearance for rapid traverse positioning when
the TNC moves the tool again to the current plunging
depth after retraction from the hole; value for the last
plunging depth. Input range 0 to 99999.9999
X
Z
Q200
Q201
Q206
Q202
Q203
Q204
Q211
Q257