HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 389)

HEIDENHAIN iTNC 530 389
15.9
D
A
TUM
FR
OM
INSIDE
OF
CORNER
(Cy
cle
415,
DIN/ISO:
G415)
 Traversing to clearance height
Q301: Definition of
how the touch probe is to move between the
measuring points:
0 : Move at measuring height between measuring
points
1 : Move at clearance height between measuring
points
Alternatively PREDEF
 Execute basic rotation Q304: Definition of whether
the TNC should compensate workpiece misalignment
with a basic rotation:
0 : No basic rotation
1 : Basic rotation
 Datum number in table Q305: Enter the datum
number in the datum or preset table in which the TNC
is to save the coordinates of the corner. If you enter
Q305=0, the TNC automatically sets the display so
that the new datum is on the corner. Input range 0 to
2999
 New datum for reference axis
Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the corner. Default setting = 0 input range
-99999.9999 to 99999.9999
 New datum for minor axis
Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the calculated corner. Default setting = 0 input
range -99999.9999 to 99999.9999
 Measured-value transfer (0, 1)
Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
–1 : Do not use. Is entered by the TNC when old
programs are read in (see "Saving the calculated
datum" on page 358).
0 : Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1 : Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).