HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 53)

HEIDENHAIN iTNC 530 53
2.1
W
or
king
with
fix
ed
cy
cles
Machine-specific cycles
In addition to the HEIDENHAIN cycles, many machine tool builders
offer their own cycles in the TNC. These cycles are available in a
separate cycle-number range:
 Cycles 300 to 399
Machine-specific cycles that are to be defined through the
CYCLE DEF key
 Cycles 500 to 599
Machine-specific touch probe cycles that are to be defined through
the TOUCH PROBE key
Sometimes, machine-specific cycles also use transfer parameters,
which HEIDENHAIN already used in the standard cycles. The TNC
executes DEF-active cycles as soon as they are defined (see also
"Calling cycles" on page 55). It executes CALL-active cycles only after
they have been called (see also "Calling cycles" on page 55). When
DEF-active cycles and CALL-active cycles are used simultaneously, it
is important to prevent overwriting of transfer parameters already in
use. Use the following procedure:
 As a rule, always program DEF-active cycles before CALL-active
cycles
 If you do want to program a DEF-active cycle between the definition
and call of a CALL-active cycle, do it only if there is no common use
of specific transfer parameters
Refer to your machine manual for a description of the
specific function.