HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 432)

432 Touch probe cycles: automatic workpiece inspection
16.7 MEA
S
. RECT
AN. INSIDE (Cy
cle
423, DIN/ISO:
G423)
 Set-up clearance
Q320 (incremental): Additional
distance between measuring point and ball tip. Q320
is added to MP6140. Input range 0 to 99999.9999,
alternatively PREDEF
 Clearance height Q260 (absolute): Coordinate in the
touch probe axis at which no collision between touch
probe and workpiece (fixtures) can occur. Input range
-99999.9999 to 99999.9999, alternatively PREDEF
 Traversing to clearance height
Q301: Definition of
how the touch probe is to move between the
measuring points:
0 : Move at measuring height between measuring
points
1 : Move at clearance height between measuring
points
Alternatively PREDEF
 Max. size limit 1st side length
Q284: Maximum
permissible length of the pocket. Input range 0 to
99999.9999
 Min. size limit 1st side length
Q285: Minimum
permissible length of the pocket. Input range 0 to
99999.9999
 Max. size limit 2nd side length Q286: Maximum
permissible width of the pocket. Input range 0 to
99999.9999
 Min. size limit 2nd side length
Q287: Minimum
permissible width of the pocket. Input range 0 to
99999.9999
 Tolerance for center 1st axis
Q279: Permissible
position deviation in the reference axis of the working
plane. Input range 0 to 99999.9999
 Tolerance for center 2nd axis
Q280: Permissible
position deviation in the minor axis of the working
plane. Input range 0 to 99999.9999
X
Z
Q261
Q260
MP6140
+
Q320