HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 331)

HEIDENHAIN iTNC 530 331
13.2
Bef
o
re
y
ou
star
t
w
o
rk
ing
with
to
uc
h
pr
obe
cy
cles
Touch trigger probe, probing feed rate: MP6120
In MP6120 you define the feed rate at which the TNC is to probe the
workpiece.
Touch trigger probe, rapid traverse for
positioning: MP6150
In MP6150 you define the feed rate at which the TNC pre-positions the
touch probe, or positions it between measuring points.
Touch trigger probe, rapid traverse for
positioning: MP6151
In MP6151 you define whether the TNC is to position the touch probe
at the feed rate defined in MP6150 or at rapid traverse.
 Input value = 0: Position at feed rate from MP6150
 Input value = 1: Pre-position at rapid traverse
KinematicsOpt: Tolerance limit in Optimization
mode: MP6600
In MP6600 you define the tolerance limit starting from which the TNC
displays a note in the Optimizing mode when the measured kinematic
data is greater than this limit value. Default: 0.05. The larger the
machine, the greater these values should be.
 Input range: 0.001 to 0.999
KinematicsOpt, permissible deviation of the
calibration ball radius: MP6601
In MP6601 you define the maximum permissible deviation from the
entered cycle parameter by the calibration ball radius measured in the
cycles.
 Input range: 0.01 to 0.1
The TNC calculates the calibration ball radius twice at every measuring
point for all 5 touch points. If the radius is greater than Q407 +
MP6601 an error message appears because it could be contamination.
If the radius found by the TNC is less than 5 * (Q407 - MP6601), the
TNC also issues an error message.
Y
X
Z
MP6120
MP6360
MP6150
MP6361