1 fundamentals, Overview – HEIDENHAIN iTNC 530 (34049x-08) Cycle programming User Manual
Page 334
334
Touch probe cycles: automatic measurement of workpiece misalignment
14.1
Fundamentals
14.1 Fundamentals
Overview
The TNC provides five cycles that enable you to measure and
compensate workpiece misalignment. In addition, you can reset a
basic rotation with Cycle 404:
Cycle
Soft key
Page
400 BASIC ROTATION Automatic
measurement using two points.
Compensation via basic rotation.
401 ROT OF 2 HOLES Automatic
measurement using two holes.
Compensation via basic rotation.
402 ROT OF 2 STUDS Automatic
measurement using two studs.
Compensation via basic rotation.
403 ROT IN ROTARY AXIS Automatic
measurement using two points.
Compensation by turning the table.
405 ROT IN C AXIS Automatic
alignment of an angular offset between
a hole center and the positive Y axis.
Compensation via table rotation.
404 SET BASIC ROTATION Setting any
basic rotation.