HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 319)

HEIDENHAIN iTNC 530 319
12.6 ENGRA
V
ING (Cy
cle 225, DIN/ISO:
G225)
Allowed engraving characters
The following special characters are allowed in addition to lowercase
letters, uppercase letters and numbers:
! # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] _
Characters that cannot be printed
Apart from text, you can also define certain non-printable characters
for formatting purposes. Enter the special character \ before the non-
printable characters.
The following formatting possibilities are available:
 \n
: Line break
 \t : Horizontal tab (the tab width is permanently set to 8 characters)
 \t : Vertical tab (the tab width is permanently set to one line)
Engraving system variables
In addition to the standard characters, you can engrave the contents
of certain system variables. Enter the special character % before the
system variable.
You can also engrave the current date. To do this, enter %time.
defines the date format whose meaning is identical to the function
SYSSTR ID332
(see the User's Manual for Conversational
Programming, "Q parameter programming" chapter, "Copying system
data to a string" section).
The TNC uses the special characters % and \ for special
functions. These characters must be indicated twice in the
text to be engraved (e.g. %%) if you want to engrave them.
Keep in mind that you must enter a leading 0 when
entering the date formats 1 to 9, e.g. time08.