HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 371)

HEIDENHAIN iTNC 530 371
15.5 D
A
TUM FR
OM OUTSIDE OF RECT
ANGLE (Cy
cle 41
1, DIN/ISO:
G41
1) Please note while programming:
Cycle parameters
 Center in 1st axis
Q321 (absolute): Center of the
stud in the reference axis of the working plane. Input
range -99999.9999 to 99999.9999
 Center in 2nd axis
Q322 (absolute): Center of the
stud in the minor axis of the working plane. Input
range -99999.9999 to 99999.9999
 1st side length Q323 (incremental): Stud length,
parallel to the reference axis of the working plane.
Input range 0 to 99999.9999
 2nd side length Q324 (incremental): Stud length,
parallel to the minor axis of the working plane. Input
range 0 to 99999.9999
 Measuring height in the touch probe axis
Q261
(absolute): Coordinate of the ball tip center (= touch
point) in the touch probe axis in which the
measurement is to be made. Input range
-99999.9999 to 99999.9999
 Set-up clearance
Q320 (incremental): Additional
distance between measuring point and ball tip. Q320
is added to MP6140. Input range 0 to 99999.9999,
alternatively PREDEF
 Clearance height Q260 (absolute): Coordinate in the
touch probe axis at which no collision between touch
probe and workpiece (fixtures) can occur. Input range
-99999.9999 to 99999.9999, alternatively PREDEF
Danger of collision!
To prevent a collision between the touch probe and
workpiece, enter high estimates for the lengths of the
first and second sides.
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
X
Y
Q322
Q321
Q324
Q323
MP6140
+
Q320
X
Z
Q261
Q260