HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 262)

262 Fixed cycles: multipass milling
10
.2
RUN
3-D
D
A
TA
(Cy
cle
30,
DIN/ISO:
G60)
Cycle parameters
 PGM name 3-D data
: Enter the name of the program in
which the contour data is stored. If the file is not
stored in the current directory, enter the complete
path. A maximum of 254 characters can be entered.
 Min. point of range : Lowest coordinates (X, Y and Z
coordinates) in the range to be milled. Input range
-99999.9999 to 99999.9999
 Max. point of range
: Largest coordinates (X, Y and Z
coordinates) in the range to be milled. Input range
-99999.9999 to 99999.9999
 Set-up clearance
1 (incremental): Distance between
tool tip and workpiece surface for tool movements at
rapid traverse. Input range 0 to 99999.9999
 Plunging depth
2 (incremental value): Infeed per cut
Input range -99999.9999 to 99999.9999
 Feed rate for plunging 3 : Traversing speed of the
tool during plunging in mm/min. Input range 0 to
99999.999; alternatively FAUTO
 Feed rate for milling 4 : Traversing speed of the tool
during milling in mm/min. Input range 0 to
99999.9999; alternatively FAUTO
 Miscellaneous function M
: Optional entry of one to
two miscellaneous functions, for example M13. Input
range 0 to 999
Example: NC blocks
64 CYCL DEF 30.0 RUN 3-D DATA
65 CYCL DEF 30.1 PGM DIGIT.: BSP.H
66 CYCL DEF 30.2 X+0 Y+0 Z-20
67 CYCL DEF 30.3 X+100 Y+100 Z+0
68 CYCL DEF 30.4 SETUP 2
69 CYCL DEF 30.5 PECKG -5 F100
70 CYCL DEF 30.6 F350 M8
4
Y
X MIN
MAX
X
Z
1
2
3