HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 205)

HEIDENHAIN iTNC 530 205
7.
9 CONT
OUR TRAIN D
A
TA
(Cy
cle
270, DIN/ISO:
G270)
7.9 CONTOUR TRAIN DATA
(Cycle 270, DIN/ISO: G270)
Please note while programming:
If desired, you can use this cycle to specify various properties of
Cycle 25, CONTOUR TRAIN and Cycle 276, 3-D CONTOUR TRAIN.
Before programming, note the following:
Cycle 270 is DEF active, which means that it becomes
effective as soon as it is defined in the part program.
The TNC resets Cycle 270 as soon as you define another
SL cycle (with the exception of Cycle 25 and Cycle 276).
If Cycle 270 is used, do not define any radius
compensation in the contour subprogram.
Approach and departure properties are always performed
identically (symmetrically) by the TNC.
Define Cycle 270 before Cycle 25 or Cycle 276.