HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 399)

HEIDENHAIN iTNC 530 399
15.12
D
A
TUM
A
T
CENTER
OF
4
HOLES
(Cy
cle
41
8,
DIN/ISO:
G41
8)  Datum number in table
Q305: Enter the number in the
datum or preset table in which the TNC is to save the
coordinates of the line intersection. If you enter
Q305=0, the TNC automatically sets the display so
that the new datum is at the intersection of the
connecting lines. Input range 0 to 2999
 New datum for reference axis Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the calculated intersection of the
connecting lines. Default setting = 0. Input range:
-99999.9999 to 99999.9999
 New datum for minor axis
Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the calculated intersection of the connecting
lines. Default setting = 0. Input range: -99999.9999 to
99999.9999
 Measured-value transfer (0, 1)
Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
–1 : Do not use. Is entered by the TNC when old
programs are read in (see "Saving the calculated
datum" on page 358).
0 : Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1 : Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).