HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 402)

402 Touch probe cycles: automatic datum setting
15.13
D
A
TUM
IN
ONE
AXIS
(C
yc
le
41
9,
DIN/ISO:
G41
9) Cycle parameters
 1st meas. point 1st axis
Q263 (absolute):
Coordinate of the first touch point in the reference
axis of the working plane. Input range -99999.9999 to
99999.9999
 1st meas. point 2nd axis Q264 (absolute):
Coordinate of the first touch point in the minor axis of
the working plane. Input range -99999.9999 to
99999.9999
 Measuring height in the touch probe axis
Q261
(absolute): Coordinate of the ball tip center (= touch
point) in the touch probe axis in which the
measurement is to be made. Input range
-99999.9999 to 99999.9999
 Set-up clearance
Q320 (incremental): Additional
distance between measuring point and ball tip. Q320
is added to MP6140. Input range 0 to 99999.9999,
alternatively PREDEF
 Clearance height
Q260 (absolute): Coordinate in the
touch probe axis at which no collision between touch
probe and workpiece (fixtures) can occur. Input range
-99999.9999 to 99999.9999, alternatively PREDEF
 Measuring axis (1...3: 1=reference axis) Q272:
Axis in which the measurement is to be made:
1 : Reference axis = measuring axis
2 : Minor axis = measuring axis
3 : Touch probe axis = measuring axis
X
Y
Q264
Q263
+
–
– +
Q267
Q272=2
Q272=1
MP6140 + Q320
1
X
Z
Q260
Q261
+
–
Q272=1
Q272=3 Q267
1
Axis assignment
Active touch probe
axis: Q272= 3
Corresponding
reference axis:
Q272 = 1
Corresponding
minor axis:
Q272 = 2
Z X Y
Y Z X
X Y Z