HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 110)

110 Fixed cycles: tapping / thread milling
4.1
Fundamentals
4.1 Fundamentals
Overview
The TNC offers 8 cycles for all types of threading operations:
Cycle Soft key Page
206 TAPPING NEW
With a floating tap holder, with automatic
pre-positioning, 2nd set-up clearance
Page 111
207 RIGID TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance
Page 113
209 TAPPING W/ CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance, chip breaking
Page 116
262 THREAD MILLING
Cycle for milling a thread in pre-drilled
material
Page 121
263 THREAD MILLING/CNTSNKG
Cycle for milling a thread in pre-drilled
material and machining a countersunk
chamfer
Page 124
264 THREAD DRILLING/MILLING
Cycle for drilling into the solid material
with subsequent milling of the thread
with a tool
Page 128
265 HEL.THREAD DRILLING/MILLING
Cycle for milling the thread into the solid
material
Page 132
267 OUTSIDE THREAD MILLING
Cycle for milling an external thread and
machining a countersunk chamfer
Page 132