HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 78)

78 Fixed cycles: drilling
3.2 CENTERING (Cy
cle
240, DIN/ISO:
G240)
Cycle parameters
 Set-up clearance
Q200 (incremental): Distance
between tool tip and workpiece surface. Enter a
positive value. Input range 0 to 99999.9999;
alternatively PREDEF
 Select Depth/Diameter (1/0) Q343: Select whether
centering is based on the entered diameter or depth.
If the TNC is to find the center based on the entered
diameter, you have to define the point angle of the
tool in the T-ANGLE column of the tool table TOOL.T.
0 : Centering based on the entered depth
1 : Centering based on the entered diameter
 Depth Q201 (incremental): Distance between
workpiece surface and centering bottom (tip of
centering taper). Only effective if Q343=0 is defined.
Input range -99999.9999 to 99999.9999
 Diameter (algebraic sign)
Q344: Centering
diameter. Only effective if Q343=1 is defined. Input
range -99999.9999 to 99999.9999
 Feed rate for plunging
Q206: Traversing speed of
the tool during centering in mm/min. Input range: 0 to
99999.999; alternatively FAUTO, FU
 Dwell time at depth Q211: Time in seconds that the
tool remains at the hole bottom. Input range 0 to
3600.0000; alternatively PREDEF
 Workpiece surface coordinate
Q203 (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
 2nd set-up clearance
Q204 (incremental): Coordinate
in the spindle axis at which no collision between tool
and workpiece (fixtures) can occur. Input range 0 to
99999.9999; alternatively PREDEF
Example: NC blocks
10 L Z+100 R0 FMAX
11 CYCL DEF 240 CENTERING
Q200=2 ;SET-UP CLEARANCE
Q343=1 ;SELECT DEPTH/DIA.
Q201=+0 ;DEPTH
Q344=-9 ;DIAMETER
Q206=250 ;FEED RATE FOR PLNGNG
Q211=0.1 ;DWELL TIME AT DEPTH
Q203=+20 ;SURFACE COORDINATE
Q204=100 ;2ND SET-UP CLEARANCE
12 CYCL CALL POS X+30 Y+20 Z+0 FMAX M3
13 CYCL CALL POS X+80 Y+50 Z+0 FMAX
X
Z
Q200
Q344
Q206
Q210
Q203
Q204
Q201
30
X
Y
20
80
50