HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 76)

76 Fixed cycles: drilling
3.1
Fundamentals
3.1 Fundamentals
Overview
The TNC offers 9 cycles for all types of drilling operations:
Cycle Soft key Page
240 CENTERING
With automatic pre-positioning, 2nd
set-up clearance, optional entry of the
centering diameter or centering depth
Page 77
200 DRILLING
With automatic pre-positioning, 2nd
set-up clearance
Page 79
201 REAMING
With automatic pre-positioning, 2nd
set-up clearance
Page 81
202 BORING
With automatic pre-positioning, 2nd
set-up clearance
Page 83
203 UNIVERSAL DRILLING
With automatic pre-positioning, 2nd
set-up clearance, chip breaking, and
decrementing
Page 87
204 BACK BORING
With automatic pre-positioning, 2nd
set-up clearance
Page 91
205 UNIVERSAL PECKING
With automatic pre-positioning, 2nd
set-up clearance, chip breaking, and
advanced stop distance
Page 95
208 BORE MILLING
With automatic pre-positioning, 2nd
set-up clearance
Page 99
241 SINGLE-LIP DEEP-HOLE
DRILLING
With automatic pre-positioning to
deepened starting point, shaft speed
and coolant definition
Page 102