HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 16)

16
New
cy
cle
functions
of
sof
tw
ar
e
34049x
-07
and
60642x
-02
New cycle functions of software
34049x-07 and 60642x-02
 New Cycle 225 Engraving (see "ENGRAVING (Cycle 225,
DIN/ISO: G225)" on page 317)
 New Cycle 276 3-D Contour Train (see "THREE-D CONTOUR
TRAIN (Cycle 276, DIN/ISO: G276)" on page 215)
 New Cycle 290 Interpolation Turning (see "INTERPOLATION
TURNING (software option, Cycle 290, DIN/ISO: G290)" on page
320)
 For the thread milling cycles (Cycles 26x), a separate feed rate is
now available for tangential approach to the thread (see the
respective description of cycle parameters)
 The following improvements were made to the KinematicsOpt
cycles:
 Newer, faster optimization algorithm
 After angle optimization, a separate measurement series is no
longer required for position optimization (see "Various modes
(Q406)" on page 492)
 Return of offset errors (change of machine datum) in the
parameters Q147-149 (see "Cycle run" on page 480)
 Up to eight plane measuring points for the measurement of
spheres (see "Cycle parameters" on page 489)
 Rotary axes that are not configured are ignored by TNC when
executing the cycle(see "Please note while programming:" on
page 488)