HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 368)

368 Touch probe cycles: automatic datum setting
15.4 D
A
TUM FR
OM INSIDE OF RECT
ANGLE (Cy
cle 41
0, DIN/ISO:
G41
0)  Traversing to clearance height
Q301: Definition of
how the touch probe is to move between the
measuring points:
0 : Move at measuring height between measuring
points
1 : Move at clearance height between measuring
points
Alternatively PREDEF
 Datum number in table Q305: Enter the number in the
datum/preset table in which the TNC is to save the
coordinates of the pocket center. If you enter
Q305=0, the TNC automatically sets the display so
that the new datum is at the center of the pocket.
Input range 0 to 2999
 New datum for reference axis Q331 (absolute):
Coordinate in the reference axis at which the TNC
should set the pocket center. Default setting = 0 input
range -99999.9999 to 99999.9999
 New datum for minor axis
Q332 (absolute):
Coordinate in the minor axis at which the TNC should
set the pocket center. Default setting = 0 input range
-99999.9999 to 99999.9999
 Measured-value transfer (0, 1)
Q303: Specify
whether the determined datum is to be saved in the
datum table or in the preset table:
–1 : Do not use. Is entered by the TNC when old
programs are read in (see "Saving the calculated
datum" on page 358).
0 : Write determined datum in the active datum table.
The reference system is the active workpiece
coordinate system.
1 : Write determined datum in the preset table. The
reference system is the machine coordinate system
(REF system).