1 fundamentals – HEIDENHAIN iTNC 530 (34049x-08) Cycle programming User Manual
Page 412
412
Touch probe cycles: automatic workpiece inspection
16.1
Fundamentals
Example: Measuring log for Touch Probe Cycle 421:
Measuring log for Probing Cycle 421 Hole Measuring
Date: 30-06-2005
Time: 6:55:04
Measuring program: TNC:\GEH35712\CHECK1.H
Nominal values:
Center in reference axis:
50.0000
Center in minor axis:
65.0000
Diameter:
12.0000
Given limit values:
Max. limit for center in reference axis:
50.1000
Minimum dimension for center in reference axis: 49.9000
Maximum limit for center in minor axis:
65.1000
Minimum limit for center in minor axis:
64.9000
Maximum dimension for hole:
12.0450
Minimum dimension for hole:
12.0000
Actual values:
Center in reference axis:
50.0810
Center in minor axis:
64.9530
Diameter:
12.0259
Deviations:
Center in reference axis:
0.0810
Center in minor axis:
-0.0470
Diameter:
0.0259
Further measuring results: Measuring height:
-5.0000
End of measuring log