HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 470)

470 Touch probe cycles: special functions
17
.7
FA
S
T
PR
OBING
(Cy
cle
441,
DIN/ISO: G441, FCL
2 F
u
nction)
17.7 FAST PROBING (Cycle 441,
DIN/ISO: G441, FCL 2 Function)
Cycle run
Touch probe cycle 441 allows the global setting of different touch
probe parameters (e.g. positioning feed rate) for all subsequently used
touch probe cycles. This makes it easy to optimize the programs so
that reductions in total machining time are achieved.
Please note while programming:
Before programming, note the following
There are no machine movements contained in Cycle 441.
It only sets different probing parameters.
END PGM
, M02, M30 resets the global settings of Cycle 441.
You can activate automatic angle tracking (Cycle
Parameter Q399) only if Machine Parameter 6165=1. If you
change MP6165, you must recalibrate the touch probe.