HEIDENHAIN iTNC 530 (34049x-08) Cycle programming - Manual (Page 502)

502 Touch probe cycles: automatic kinematics measurement
18
.5
PRESET
COMPENSA
TION
(Cy
cle
452,
DIN/ISO:
G452,
Option)
 Insert the second interchangeable head
 Insert the touch probe
 Measure the interchangeable head with Cycle 452

Measure only the axes that have actually been changed (in this
example: only the A axis; the C axis is hidden with Q422)
 The preset and the position of the calibration sphere must not be
changed during the complete process
 All other interchangeable heads can be adjusted in the same way
Example: Adjusting an interchangeable head
3 TOOL CALL "TCH PROBE" Z
4 TCH PROBE 452 PRESET COMPENSATION
Q407=12.5 ;SPHERE RADIUS
Q320=0 ;SET-UP CLEARANCE
Q408=0 ;RETR. HEIGHT
Q253=2000 ;F PRE-POSITIONING
Q380=45 ;REFERENCE ANGLE
Q411=-90 ;START ANGLE A AXIS
Q412=+90 ;END ANGLE A AXIS
Q413=45 ;INCID. ANGLE A AXIS
Q414=4 ;MEAS. POINTS A AXIS
Q415=-90 ;START ANGLE B AXIS
Q416=+90 ;END ANGLE B AXIS
Q417=0 ;INCID. ANGLE B AXIS
Q418=2 ;MEAS. POINTS B AXIS
Q419=+90 ;START ANGLE C AXIS
Q420=+270 ;END ANGLE C AXIS
Q421=0 ;INCID. ANGLE C AXIS
Q422=0 ;MEAS. POINTS C AXIS
Q423=4 ;NO. OF MEAS. POINTS
Q432=0 ;BACKLASH, ANG. RANGE
The head change function can vary depending on the
individual machine tool. Refer to your machine manual.